Maxwell Render | Official public forum

Hey there!

Is there anywhere I can acquire a 3D model of an entire house / flat? I don't care much about the exterior or if it's one or two levels, but it would ideally be fully furnished. This will be used to showcase sliding doors (maybe fade from swing door to sliding door). It's a commercial project for the company I work for, but of course (or therefore, haha) cost is an issue.

C4D or Rhino format preferred.

Any of you arch viz people know of a good source (or any at all, actually, seeing that I'm asking a lot here )?

Thanks!

Johann

Bonus points if it comes ready with Maxwell 1.7 materials

Evermotion Archinteriors?!?

http://www.evermotion.org/modelshop/show_products/0

This looks pretty good already, thanks! Think I might go for the 3dsmax versions though, cause there's more choice and even the C4D models are textured only for VRay. Are there going to be issues importing a 3dsmax model into C4D R10?

HI Johann

We are busy with a new home of about 800m² with a lot of sliding/ folding-stacking doors.

You are welcome to the model allthough it is in sketchup format.

Could export to 3ds

Regards

Andre

andrekrige wrote:HI Johann

We are busy with a new home of about 800m² with a lot of sliding/ folding-stacking doors.

You are welcome to the model allthough it is in sketchup format.

Could export to 3ds

Regards

Andre

PM sent, thanks Andre!