Ferro-fluid scupltures
Posted: Tue May 22, 2007 3:19 pm
Maxwell Render | Official public forum
The official Maxwell Render public forum. A place to share your latest projects and be inspired by others, or get help and feedback from the Maxwell community
https://forum.maxwellrender.com/
Ferro-fluid scupltures
Page 1 of 1
Posted: Tue May 22, 2007 3:53 pm
oh my +1
Posted: Tue May 22, 2007 5:33 pm
Are these some cut out scenes from T4?
Posted: Thu May 24, 2007 4:52 pm
After I saw this post I did a little searching. You can buy the stuff easily but it's a little expensive...
I saw a post about a guy that made his own. Basically take magnetic toner cartridge powder (it's commonly used to make checks that can be franked). You mix the toner with oil (he used 30 weight motor oil) until you have a nice colloidal mix. Run a magnet under the mess and there you go... he does warn (and I know from experience!) do NOT get the powder on anything; it is a nightmare to clean... have fun maniacs!
I saw a post about a guy that made his own. Basically take magnetic toner cartridge powder (it's commonly used to make checks that can be franked). You mix the toner with oil (he used 30 weight motor oil) until you have a nice colloidal mix. Run a magnet under the mess and there you go... he does warn (and I know from experience!) do NOT get the powder on anything; it is a nightmare to clean... have fun maniacs!
Posted: Fri May 25, 2007 1:35 am
Posted: Fri May 25, 2007 2:25 am
Too cool.
I wish I had time to play like that.