Page 1 of 1
SU > MR Camera matching!
Posted: Thu Jan 15, 2009 1:04 am
by Richard
There was a question put on the PushPullBar regarding how to match the MR export to the SU camera!
I didn't have an answer as I just count on trial and error or opening studio to enable correct camera setting!
Does anyone have a true and definative answer here?
Posted: Thu Jan 15, 2009 5:18 pm
by marked001
use one of the cameras in the Film and Stage plugin...and it will match.. i know they claim it will match the viewport w/o this, but i've never had this experience.
Posted: Thu Jan 15, 2009 11:27 pm
by Richard
marked001 wrote:use one of the cameras in the Film and Stage plugin...and it will match.. i know they claim it will match the viewport w/o this, but i've never had this experience.
Thanks dude that was my suggestion too as I've been doing that since v1.5 though mindful I only get a close match not a true match! And then never if I use a shift lens setup - which I would expect anyway!
Posted: Sun Jan 18, 2009 9:11 pm
by pelias
You can match without Film&Stage as well - you just have to make sure that the resolution of the rendered image (its aspect ratio) matches the film size in Maxwell camera settings.
Pavol