Maxwell Render | Official public forum

I'm having a problem with my lighting. I am using a 2x2 fluorescent light fixture (slightly modified Sketchup component) and I applied an emitter material to the under side. There are 26 fixtures and the emitter material settings are as follows...
temp: 6000K
Watts: 26,000
Efficiency: 63
For some reason the light is not reaching the floor also the first light fixture that I inserted is much brighter than the rest. I've circled the offending light in the image. Does anyone have any ideas why this is?
Thanks,
Jamie

[img]http://www.welmanarch.com/images/lighting-test4.jpg[/img]

Jamie!!

It's me!! I see you posted this--it would have been a great question, but the image you attached isn't showing up. I think you should try it again because I'm having the same problem.

Erin