Page 1 of 1

Maxwell 4 Rhino 6 - Render poperties not saved or used

Posted: Wed Apr 15, 2020 5:46 pm
by Dinell Johansson
Hey,

Making changes to the render porperties such as SL or output channels does not seem to have any effect. E.g. if I check MaterialId under "Output" and render I still only get main channel and when I go back to render properties the box is unchecked. Same goes for all options.
Has anyone else experienced this?
Workaround is to make changes directly in Maxwell once the render has started.

/Björn

Re: Maxwell 4 Rhino 6 - Render poperties not saved or used

Posted: Sun May 03, 2020 10:40 pm
by Dinell Johansson
No remedy for this issue?
Do I have to buy Maxwell 5 in order for it to work in Rhino 6?

Re: Maxwell 4 Rhino 6 - Render poperties not saved or used

Posted: Mon May 04, 2020 11:21 am
by Forum Moderator
Hello Björn,

Are you maybe setting those options from the Document Properties window? I would try to set them in the Renderer panel instead. I'm not sure right now but, if I'm not wrong, there were some issues storing the settings from the floating windows.
Also, as a general rule, I would try to keep Rhino up to date, as they also fix tings in the SDK that could be affecting the plugin behavior.

Does this method work better?

Best,
Fernando

Re: Maxwell 4 Rhino 6 - Render poperties not saved or used

Posted: Mon May 04, 2020 5:21 pm
by Dinell Johansson
Thanks for your reply Fernando,
I was indeed setting the values from menu item Render > Render Properties rather than from the Render tab (which I guess is the renderer panel).
Setting from render panel seems to work!
Thanks again,
Bjorn