Maxwell Render | Official public forum

Dear all,

i have just tried to render an animation while using the denoiser but I found out that it does not work properly (at least not with my workstation).

When rendering only one frame the denoiser runs fine. When rendering 2 or more frames the behavior of the denoiser changes. It does not render 1 pass until SL4 and then the second pass but renders the first pass until final SL and then starts the second pass until SL4. Then it denoises the first time and after that it runs into an error that the mxi cannot be continued.

Does some have noticed the same issue? Is there any workarround?

regards
Dominic

Hello metami.

You are right. This behavior is repeatable and it will be fixed as soon as possible. The good news are that there is a workaround. You only have to switch the denoise Each SL option to At End. It seem that otherwise the animation process is broken.

Thank you for pointing at this.