Everything related to Maxwell Render and general stuff that doesn't fit in other categories.
User avatar
By tom
#392096
Oh, OK! Because "ghost" (nd=1 & trans=255) is a special case for the engine. It's perfect vacuum which is excluded from computations like refraction etc. Therefore, you can set it 254 and then expect it behave like a dielectric again ;)
User avatar
By seghier
#393147
i added new layer with procedural checker (hatch ) and masked it with checker ( half black/half white ) with plane mapping
than i scaled the mapping and moved it a little bit to got this result

in this case i added two layers for hatch ; i don't know why hatching appeared only in half of the model
MaxRen 5 Not Working.

I am having the same issues with Next Limit right […]

I currently use Rhino 5 and Maxwell 4 for mac at w[…]

I cannot find anything about this issue online and[…]

Before I decide to completely switch over to Rende[…]