Maxwell Render | Official public forum

After resuming existing scene containing references, instances of references slowly disappear from scene. Also after restarting such scene (clicking restart) there are no instances of references on scene. I'll try to take screens to show this.

Any news about it? It's troublesome, because clicking resume on render with references will make it unusable...

Are you sure you're not rendering an updated version of the scene? This is what usually happens if you changed an MXS and resume it, the objects that have changed positions will slowly "blend" with the result of the previous calculations in the MXI.

I'm sure. Scene just exported and then resumed, with referenced objects, no referenced - no problem. I'm not sure if it always happens, but I can check. But when I use resume mxi from maxwell menu all is fine.

I think I've seen the same thing rendering from SketchUp. It's been awhile and I didn't dig into it too deeply but I'm pretty sure it was there too...

I can add that if I start render and immediately stop even before voxelisation and then start again there will be only first instance visible of each instance model.