Page 1 of 1
Adjust MXCL colors and program locks
Posted: Tue Sep 29, 2009 10:29 pm
by Gary
Title says it all. I can make the color adjustments but then only get lock up/spinning beach ball. On restart, adjusted colors are not displayed.
On MXED (revised app emailed from Nacho) I was also able to adjust colors, got the same beach ball, had to force quit. On restart, adjusted colors are displayed.
Gary
Re: Adjust MXCL colors and program locks
Posted: Wed Sep 30, 2009 7:17 pm
by Mihai
Do you mean color MultiLight? Keep in mind it will use more ram than Intensity only mode, depends ofcourse on the resolution and nr of emitters. You should check it's not starting to use the scratch disk.
Re: Adjust MXCL colors and program locks
Posted: Wed Sep 30, 2009 8:25 pm
by Gary
Sorry, I was not clear. No, I was referring to adjusting the colors of the interface in MXCL and MXED under preferences.
Gary
Re: Adjust MXCL colors and program locks
Posted: Thu Oct 01, 2009 11:26 am
by sampson
yup confirmed - it locks up the program when the warning "restart the application to apply changes" is displayed. Requires force quit but on re-opening the app the new colours are loaded.
Re: Adjust MXCL colors and program locks
Posted: Thu Oct 01, 2009 4:39 pm
by Gary
I only get the new colors displayed when re-opening MXED, not MXCL.
Gary
Re: Adjust MXCL colors and program locks
Posted: Thu Oct 01, 2009 4:55 pm
by sampson
Yup sorry, same here.
Also the same in studio (but new colours load after restarting the app)