Rendering animations in SW
Posted: Thu Dec 01, 2005 3:43 pm
by Gunnar
Hi All,
Is it possible to render animations made with SolidWorks Animator ?
Regards
Gunnar
Posted: Fri Dec 02, 2005 12:10 am
by John Layne
Today I can say no it does not, tomorrow when the Release Candidate is released I can say I have no idea if it will.
If it is not possible in RC1 I hope they add this functionality. I have asked a similar question in the past but did not receive definitive answer. If Next Limit had stated they were going to add this, I would have purchased at least one more licence.