By lghtstrm
This isn't really a SolidWorks question but I hear there are some similarities between SolidThinking and SolidWorks and since ST does not have a forum I thought I'd throw this out to you guys and see if you can help.

I'm creating models in SolidThinking and importing them as .3ds into Maxwell Studio. As you can see from the first image below even with tests with smoothing between 60 and 360 I was still getting faceting.


So I went back to the modeler and really cranked up the polymesh tolerance to .001. Modeler smoothing was set to 90.

Then I brought the models back in and it appeared to have cleaned up nicely, but upon close inspection you can see that it is still faceting in the highlight on the left.


Any thoughts or help would be welcome.

Feedback welcome.

Design + Illustration
hardware question :)

I can easily create an usable render in 15/20 mi[…]

Maxwell for Rhino on Max missing Toolbar

Hello, For some reason, the Mac version of Rhino[…]

Let's talk about Maxwell 5.2

Price for sure matter a loot. Speed is the core i[…]

Materials translucent with V5.1

Well, the problems can be in the chair, the monito[…]