Maxwell Render | Official public forum

Sorry if this is a known question.... :

1. While in studio I can apply an emitter to single polygons this does not work in SW. If I take a single object it works fine. Does anybody know how ?

2. Sometimes it´s important to control the mesh-resolution of a sw-part. Is this possible in SW-plugin?

Thanks a lot..

Q1) you can assign them in Studio, but you can't render them - emitters are not allowed as sub-object materials
Q2) you should use SolidWorks Document Properties > Image Quality to adjust the mesh density

Cheers...

Hello JD

.. thanks a lot - solved ...