By jjs
#260463
Haven't picked up this one before, and have not used maxwell for a while.

I have an assembly - before applying any materials etc I breifly rendered it as is and it was all there in the render.

I thought "hang on I'll just add a few textures and colours and then render". Did that and now the parts in the assembly are just not rendered. The are transparent completely, while the other parts not assigned anything, appear in the default colour.

Got this error

Exception Message: Attempted to read or write protected memory. This is often an indication that other memory is corrupt.


what does this mean?

Regards


Jonathan
By JDHill
#260464
Hi Jonathan,

If this is repeatable, could you please send the error report when the error dialog is shown? It could be any number of things - something with the model, an error inside SW, or an error inside the Maxwell SDK - the error report should help me tell what's happening.

Thanks,

JD
By jjs
#260471
Jd - Will PM you the report


Jonathan
By jjs
#260481
strange - - its not happening now. I had to restart my machine for another erason , and now the assembly is rendering - I'll get back to you JD when i have my story straight.

I panic too easily! :D

Jonathan
By JDHill
#260485
No problem, if it happens again, just try to remember to click the 'Send Report' button on the error dialog - the report goes straight to my inbox, with the full session log attached, along with some info about your machine status that might be useful.

Cheers,

JD
render engines and Maxwell

Funny, I think, that when I check CG sites they ar[…]

Hey, I guess maxwell is not going to be updates a[…]

Help with swimming pool water

Hi Choo Chee. Thanks for posting. I have used re[…]