Page 1 of 1
Exception Report
Posted: Fri Nov 23, 2007 10:12 pm
by w i l l
Why is this popping up every 5 seconds and how do i stop it?
Posted: Fri Nov 23, 2007 10:21 pm
by JDHill
I would need to know what you're doing, and what it's saying. You should see text printed in the Log Viewer - this would be helpful. It would also be good to send one of the reports so I can take a look.
Also, what version of SW are you on?
Posted: Sat Nov 24, 2007 12:48 am
by w i l l
Will this update work with Solidworks 3.0? Is it possible to use the 1.5 plugin and save an mxs for 1.6 Studio?
Posted: Sat Nov 24, 2007 12:53 am
by JDHill
The new plugin is for SolidWorks 2007 SP3.1 and greater. As far as I know, the old plugin should work ok with Maxwell 1.6, but I haven't tested that.
Posted: Sat Nov 24, 2007 2:10 am
by w i l l
I'm pretty sure this was due to me using a lower service pack - i just tried it with 3.0 and it seems to work.
Posted: Sat Nov 24, 2007 2:30 am
by w i l l
Like the new interface by the way - looks better than Studio.