Exception Report#252500 By w i l l - Fri Nov 23, 2007 10:12 pm - Fri Nov 23, 2007 10:12 pm #252500 Why is this popping up every 5 seconds and how do i stop it? behance - linkedin - tumblr
#252506 By JDHill - Fri Nov 23, 2007 10:21 pm - Fri Nov 23, 2007 10:21 pm #252506 I would need to know what you're doing, and what it's saying. You should see text printed in the Log Viewer - this would be helpful. It would also be good to send one of the reports so I can take a look. Also, what version of SW are you on? Next Limit Team
#252555 By w i l l - Sat Nov 24, 2007 12:48 am - Sat Nov 24, 2007 12:48 am #252555 Will this update work with Solidworks 3.0? Is it possible to use the 1.5 plugin and save an mxs for 1.6 Studio? behance - linkedin - tumblr
#252557 By JDHill - Sat Nov 24, 2007 12:53 am - Sat Nov 24, 2007 12:53 am #252557 The new plugin is for SolidWorks 2007 SP3.1 and greater. As far as I know, the old plugin should work ok with Maxwell 1.6, but I haven't tested that. Next Limit Team
#252590 By w i l l - Sat Nov 24, 2007 2:10 am - Sat Nov 24, 2007 2:10 am #252590 I'm pretty sure this was due to me using a lower service pack - i just tried it with 3.0 and it seems to work. behance - linkedin - tumblr
#252593 By w i l l - Sat Nov 24, 2007 2:30 am - Sat Nov 24, 2007 2:30 am #252593 Like the new interface by the way - looks better than Studio. behance - linkedin - tumblr