Maxwell Render | Official public forum

the command-line commands in my .bat are not catching on maxwell_3.

neither the picture size nor the sampling level would override the values in the .msx .
So instead of 80x80 pix, i get the 800x800 frm the .mxs.
and instead of sl:4 i get the sl:6 of the .mxs as well.


I used .bat in the past and it was all fine with overriding, why am i having problems with maxw_3 ? Am i doing something wrong or is there possibly a bug ?

Regards,
Frank

It should be -res:80x80 not -Camera:res:80x80

hi Tom, ya had that before, but still not coming through.

is there a new command line setup for maxw_3 ?

pls help with the command line issue, not sure how then to re-render with different settings without re-exporting the animation each time.

I think there was a bug regarding this, when using animation. Can you try without the -frames flag and just rendering one frame? You've updated to 3.0.1?

Hi,
yes when taking out frames from command line, the -res works fine om 3.0.0.
i then went ahead to upgrade to 3.0.1 and check from there, but having some install troubles http://www.maxwellrender.com/forum/view ... 35&t=42256

Thx,
Frank

k i checked 3.0.1 but the bugs yet still are there. pictures still not catching the -res: when using -frames:, also -region: is not coming yet, always rendering full image.

So -region isn't working, even without the -frames flag? Are you sure?

ya, just tested again. also without -frames: its always rendering full image.
-res: works this way though

Hi Mihai,
any news with the command line issues ?

Regards,
Frank