Maxwell Render | Official public forum

Posted: **Sat Dec 07, 2013 10:24 pm**

Ok, opened an previous scene created in Maxwell Studio V2. Opened all fine but all my texture coordinators and mappings are screwed up. Anyway, I fired up a Fire Preview render and all looked good and worked out as expected. Actually it looked much better than the old version...

Now I wanted to check exporting/rendering the scene in 100x1000px in Maxwell render.
After clicking the "Render" button in Maxwell Studio V3, Maxwell render started and crashed immediately!

Tried again- same thing.....
and again....

you get the picture...

Now what?

Q!

Posted: **Sat Dec 07, 2013 10:27 pm**

OSX/Win? Are you sure Maxwell is licensed correctly? (open console and see if you get any errors, look at the top of the console, where it lists info about your license and computer etc.)
Please see your post about licensing, I replied there.

Posted: **Sat Dec 07, 2013 10:43 pm**

Mihai... check my answers...

My setup consists of two Mac Pros and a MacBook Pro.

I usually work with Maxwell Studio on OSX but also sometimes on WIN 8 running on the other MacPro. That's why I need Studio to be licensed on both MacPros.

Right now I just try to get it working on the main MacPro.

Q!

Posted: **Sat Dec 07, 2013 11:11 pm**

WORKING!

Turned off the OSX firewall and Maxwell render started like it should!

Maxwell Render | Official public forum

[SOLVED] Fire rendering - Maxwell Render not!

[SOLVED] Fire rendering - Maxwell Render not!

Re: Fire rendering - Maxwell Render not!

Re: Fire rendering - Maxwell Render not!

Re: Fire rendering - Maxwell Render not!