Page 1 of 1
It looks like I can not rotate my HDR
Posted: Wed Jul 30, 2008 11:54 pm
by caryjames
Hi Everyone: I was wondering why I couldn't change the lighting appearance of a jewellery scene that I am lighting using an HDRI. I decided that I would run a little test to see if I could get to the bottom of the issue. I ran a little test with a simple metal sphere and my HDR. It doesn't seem to matter what I do the lighting stays in the same position.
Here is my scene at 0 rotation
60degree rotation
120 rotation
240 rotation
I am in the Rhino plug in under the Environment tab and am selecting scene rotation. Am I doing something wrong? This is an HDR that I purchased from HDRI Studio so I know that the file is good. Any thoughts would be more than welcome!!
Thanks in advance
Cary
Posted: Thu Jul 31, 2008 12:33 am
by JDHill
The problem is that Scene Rotation is the wrong thing to use for this - you need to use the Scale and Offset parameters for the Image Based channel you want to adjust. Scene Rotation is used to adjust where North points to in the Rhino scene, that is, it affects Physical Sky - I'll try to clarify this a bit more next time I update the plugin manual.
Posted: Thu Jul 31, 2008 2:13 am
by caryjames
So JD... how would I rotate the HDR around my scene? Could you point me in a direction? Sorry again to be obtuse
. Thanks.. and I am headed to the manual again to see if it has anything on this issue.
Cary
Posted: Thu Jul 31, 2008 2:30 am
by JDHill
Here's what you're looking for:
If you use click/drag on those fields, you'll find the adjustment can be seen in the viewport as you do so. Note, the offset units are in percent.
Cheers...
Posted: Thu Jul 31, 2008 2:51 am
by caryjames
Thanks JD!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Posted: Fri Sep 05, 2008 3:42 pm
by Brian_Law
Hi JD,
Is it always good to Disable "Physical Sky" under the Disable Channel under the Image Based setting? I see that you disable this for the below example. Also from read your tutorial forum for Rhino, you also Disable channel for physical sky too. What are the good advise on this?
Posted: Fri Sep 05, 2008 4:27 pm
by JDHill
Hi Brian,
I'm not sure I understood the question - Physical Sky is not disabled for Image Based lighting in this example. To do so, one would set 'Disabled Channel Lighting' to 'None'. In this example though, it would not matter what 'Disabled Channel Lighting' was set to, since all four Image Based channels are being used.
Just let me know if I've misunderstood what you're asking.
JD