Page 1 of 1
Bathroom render
Posted: Sun Apr 24, 2005 2:13 pm
by Frances
Can anyone give me some tips on using an emitter object for the Sun? Should I use a simple plane? How big? What intensity and type of intensity? The attached render uses an emitter panel outside of the window and emitter materials in two ceiling fixtures and the vanity sidelights. Also, tips on using Burnt.
C&C are welcome.
deleted
Posted: Sun Apr 24, 2005 10:08 pm
by Frances
Thanks! I'll try that.
Posted: Mon Apr 25, 2005 8:45 pm
by Frances
Thanks Adam.
Do you know anything about the Units options for emitter intensity in Rhinoll? I looked up exitance and radiance, but can't determine what unit is appropriate for what type of light.
Posted: Tue Aug 23, 2005 5:50 pm
by Sebas
Hi Frances.. mind sharing the settings ffor the porcelain ? Thanks
Posted: Wed Sep 07, 2005 1:08 am
by Frances
Sebas wrote:Hi Frances.. mind sharing the settings ffor the porcelain ? Thanks
I don't remember exactly. It's just a creamy white plastic, I think. With Rhinoll, the material definitions are lost with plug-in upgrades. Anyway, I see where you've gotten some good info from another user.
Posted: Wed Sep 07, 2005 4:30 am
by MarkM
Frances,
Very lovely render!
Sebas wrote:Hi Frances.. mind sharing the settings ffor the porcelain ? Thanks
Sebas,
I have read a post were someone used these setting for porcelain that looked pretty good...
Plastic Material
color:220
Specular: 101,101,101
UV Roughness: .03
Regards,
mark