Maxwell Render | Official public forum

I have got net render set up on my desktop and laptop. My desktop is running the manager and monitor. Everything gets connected and looks like it is good to go. When I go to add a job however I cannot find where to pull the mxc (maxwell configuration) file from. Is rhino supposed to create the mxc file like it creates the mxs file, but it currently can't?

I went ahead and sent it anyway with the mxc file, and both servers start to kick in. The laptop gets past the voxellizing, but after that in the server cmd promt it stays at sampling level 0 can't open c:Maxtemp.........jpg The desktop renders away through the sample levels, but the laptop just sits there at sample level 0.

An interesting thing happened though. My server cmd prompt on my desktop crashed, and then the laptop starts to render the scene like it should. Is this because I didn't specify a mxc location? How do I create an mxc file?

hmmm did some digging. I am assuming this would have to do with under the output options misc-not yet supported command line options?

Creating this in a text file will not always be the case will it? This program will blow away the competition if it can relatively seamlessly use other cpu's on the network to render a single still. I have a g4, and a laptop doing nothing that could speed up my renders a bunch. I am very impressed with the scene setup time, and quality of the tests I have done so far. Just very slowww But I expected this going in.