Page 1 of 1

image only

Posted: Thu Aug 05, 2010 3:26 pm
by Asmithey
Hi there,

When I select image only for the output option, it will render one image. When I try to render a secoond image, I get an error message that states it can not write to the specified path. If I go and delete the image from the destination folder, it will then render the image again. It does not seem to be adding the unigue file names.

Aaron

Re: image only

Posted: Tue Aug 10, 2010 5:55 am
by pylon
Hi,
Is anyone else reproducing this?
Ben

Re: image only

Posted: Wed Aug 11, 2010 12:43 am
by Asmithey
It worked for me when I set the image type to png. Not sure what was happening. Maybe it was a file naming conflict.