- Tue Jun 19, 2012 6:59 am
#357248
1/ Mirrored parts moving even with instances turned off.
2/ If add-in is turned off then on again, the Maxwell tab goes blank. Only way to restore is to check "start-up" on the Maxwell add-in and restart SolidWorks. Note I normally have the Maxwell add-in turned off, due to instability issues in SolidWorks when it's on.
2/ If add-in is turned off then on again, the Maxwell tab goes blank. Only way to restore is to check "start-up" on the Maxwell add-in and restart SolidWorks. Note I normally have the Maxwell add-in turned off, due to instability issues in SolidWorks when it's on.
John Layne
http://www.solidengineering.co.nz
"The mass of men lead lives of quiet desperation"
Henry David Thoreau 1854
http://www.solidengineering.co.nz
"The mass of men lead lives of quiet desperation"
Henry David Thoreau 1854