Maxwell Render | Official public forum

Hi once again
I sometimes got problems adjusting a custom mesh for displacement:

Why are the planar faces nicely meshed into 5x5cm and the curved wall isn't? The mesh is not split horizontally there.
Thanks for the help.
Cheers, kami

Is this Rh5 Beta? If yes it is a known bug of the current mesher to disregard the aspect ratio settings.
You might try the TestNewmesher Command - it allows you to use the old mesher instead.

thx a lot. that has worked. didn't know about the issue.

Polyxo wrote:You might try the TestNewmesher Command - it allows you to use the old mesher instead.

Orwellian.