Maxwell Render | Official public forum

Hi Jeremy
Sorry to bother you with a rhino5 issue, but I got a major problem with the latest wip.
Every new object I create (except for meshes) is not rendered. In a new file I get the message: "Maxwell: there are no objects to render"
Do you know any workaround for this?
Thanks
Kami

Are you using the new 'Extrusion' objects?

just by accident ... it must have been enabled by default. I changed it back to polysurface and it works now
thank you very much !!!!
I didn't know about this new feature. Looks interesting because I noticed that a lot of polysurfaces made rhino very slow

Interesting...I would assume that you're holding off with updating the plugin until McNeel decides which way to go with these lw extrusions?

In theory, a plugin should not be concerned with this. I haven't personally tested them, so I can't comment on if/why they are not working, but I would expect them to begin working in some upcoming WIP.

kami wrote:just by accident ... it must have been enabled by default. I changed it back to polysurface and it works now
thank you very much !!!!
I didn't know about this new feature. Looks interesting because I noticed that a lot of polysurfaces made rhino very slow

how to chech back to polysurface??
I get message "there is no object to render"

In the command line, type UseExtrusions, then click Polysurface. To turn them back on, do the same, but select Extrusion.

thanks.