Page 1 of 1
controlling smoothing by object in Rhino?
Posted: Sun Mar 28, 2010 4:06 am
by Josephus Holt
I'm working on a chandelier with crystal glass. Is there a way in Rhino and/or the MW plugin to have custom smoothing angles by object, like the phong tag in C4D?
Re: controlling smoothing by object in Rhino?
Posted: Sun Mar 28, 2010 7:13 am
by JDHill
You will want to use Mesh > From NURBS Object, then use the Weld command to adjust smoothing on the resulting mesh.
Re: controlling smoothing by object in Rhino?
Posted: Sun Mar 28, 2010 10:16 pm
by Josephus Holt
JDHill wrote:You will want to use Mesh > From NURBS Object, then use the Weld command to adjust smoothing on the resulting mesh.
I see, "angle tolerance". Thx, Joe