Maxwell Render | Official public forum

JD, while in the proces of getting the latest Rhino wip (required) I had to uninstall and reinstall Rhino v5 wip. I've got Rhino x64 v5 installed and I'm trying to get Maxwell installed again without success. I extracted the files and copied them into the Rhino x64 v5 plugin folder, and ran the Maxwell plugin setup there. Is that the right way to do it? I just don't remember how I've done it in the past (FYI: might be helpful to spell that out in the readme file? anyway here is the screenshot, can you help me out so I can go back to work? thx much as always, Joe

No, it's due to a different problem -- normally, you would just unzip the download anywhere you have permission to install from, and run it. But the Rhino V5 WIP installer and mine are not getting along right now, so: try downloading this and unzipping it on your desktop. Go into the unzipped folder, double click the MostRecent_x64.reg file, click Yes when asked whether you want to add something to the Registry, and then try the plugin installer again.

Thank you for the immediate reply. That worked although had to do a manual plugin install inside Rhino. Everything should be good to go, will try it out here in a few minutes after I get all my toolbars back . Thx again, Joe

Plugin-wise, remember you always have the Maxwell_ToolbarReset command.