- Tue Aug 25, 2015 12:38 pm
#387807
Dear group,
I'm trying to create an average lightbulb. However when I try to render the image, the glass of the bulb seem to "block" the emitter of the filament. I cannot figure out what I am doing wrong.
The glass of the bulb is 0,5 mm thick. Also I noticed a difference in a Fire render (even when I set the values very high), the actual render in MW and the preview in MW. It seems the preview is doing the render as expected.
Kind regards
Marc
P.S. Maybe a dumb question, but I would like to attach images, but haven't found out how to:)
I'm trying to create an average lightbulb. However when I try to render the image, the glass of the bulb seem to "block" the emitter of the filament. I cannot figure out what I am doing wrong.
The glass of the bulb is 0,5 mm thick. Also I noticed a difference in a Fire render (even when I set the values very high), the actual render in MW and the preview in MW. It seems the preview is doing the render as expected.
Kind regards
Marc
P.S. Maybe a dumb question, but I would like to attach images, but haven't found out how to:)